CREATOR CHINA
2013-09
WWW.CREATOR1997.COM
10
WiFi Conference System U
ser„s Manual
3.3 CR-WiFi6202/4B Function
Characteristics
◆
The DHCP settings, each conference unit with
an independent IP address;
◆
WiFi transmission technology, strict digital
protection to ensure the privacy of the meeting, to
avoid malicious eavesdropping and jamming;
◆
Capacitor heart type direction microphone, with
two colors indication lamp ring; speech is red,
when it is lack of electricity, the green light
flashing;
◆
With a 3.5mm stereo headphone jack and the
volume control function;
◆
The built-in speaker, with volume control
function;
◆
LCD display with backlight, can display the
microphone on / off, ID settings and other
information;
◆
Chairman unit is also affected by the largest
number of speaker
s‟ restrictions;
◆
Chairman unit has priority on closing speaking
units;
◆
Built-in rechargeable lithium battery, battery
capacity to support 9 hours of continuous speech
or static standby 13 hours;
◆
Using special 5 core high density airline
interface;
◆
The professional meeting microphone, nut
knob type joint connecting, can freely swap;
◆
The built-in loudspeaker;
◆
Automatic frequency control function, when
microphone is turned on, the built-in loudspeaker
automatically shut down to prevent voice
reinfusion.
3.4 CR-WiFi6202/4B Operating
Instructions
3.4.1 CR-WiFi6202/4B ID Setting
Before the initial use of WIFI conference system,
the ID setting to all the meeting units is need to
make sure normal use. The specific ID setup
steps are as the following.
3.4.2 Using of CR-WiFi6202/4B
Once the ID is set for the first use, just press the
power switch of unit in the later use, unit LCD will
be lit and begin to work. When the unit is initialed,
it will automatically connect to the wireless AP
access device set in ID setting, and work normally
after then.
When in normal work, press the microphone
switch button, the red rod indicator is lit up. The
speaker can start speech.
In NORMAL mode, once the number of units with
opened microphone reaches the numerical value
set by ACTIVE MICRO'S, the later units cannot
open microphone any more.
In FIFO mode, once the number of units with
opened microphone reaches the numerical value
set by ACTIVE MICRO'S, the later unit which
opens microphone will take the place of the first
unit with opened microphone, on and on. The
microphone opened by chairman machine cannot
be taken over.
Long press the chairman machine microphone
switch button can turn off the opened
representative microphone in priority.
Volume control button can adjust the volume of
headphones and loudspeakers simultaneously.
Press the volume increase and decrease keys at
the same time, can see the unit IP and the
connected wireless AP access device.
The unit machine needs to work in the
range of 30 m around the wireless AP access
to
ensure
the
good
wireless
signal
