2
Installing CTCM & CTCU
To install Creative PnP Configuration Manager (CTCM) and Creative
PnP Configuration Utility (CTCU) in DOS/Windows 3.1x:
1. Load the installation CD-ROM into your CD-ROM drive.
2. From the Windows File Manager, select File, Run
and type D:\WIN31\DISK1\SETUP
3. Follow the instructions on the screen to complete the
installation.
CTCM is installed as part of the software installation, and the
following line added to the CONFIG.SYS file:
DEVICE=<C:\SB16>\CTCM.EXE
where <C:\SB16> is the directory where you have installed CTCM.
This CTCM statement will be placed before all the statements that
load other low-level device drivers (such as CTSB16.SYS and
SBIDE.SYS) so that your Creative PnP cards will be configured
before these device drivers try to use them.
If you add this line to CONFIG.SYS manually, please make
sure that this line is placed after the statement (if any) that loads
the other PnP configuration manager in your system.
The installation program will also add the following lines to the
AUTOEXEC.BAT file:
SET CTCM=<C:\SB16>
<C:\SB16>\CTCU /S /W=<C:\WINDOWS>
where <C:\SB16> and <C:\WINDOWS> are the directories where
your CTCM/CTCU and Windows 3.1x files are installed respectively.
This manual downloaded from http://www.manualowl.com
