YORKTOWN
19794-300 Rev J (05-20)
© Copyright 2010, Creative Playthings
Page 13
ASSEMBLY INSTRUCTIONS
Step 10 — Inside Stringers:
Locate the three Inside Stringers (E). Install the Inside
Stringers between the Left Platform Support and the Center
Platform Support. Fasten each Inside Stringer using 5/16 x
4" Lag Screws and Flat Washers through the Left Platform
Support and 5/16 x 5-1/2" Lag Screws and Flat Washers
through the Center Platform Support as shown.
Step 11 — Porch Central Stringers:
Fasten an Access Bracket to the end of each Central String-
er (AC) using a 5/16 x 1-1/2" Hex Bolt Assembly as shown.
Fasten the Access Brackets to the Central Platform Support
using 5/16 x 3-1/2" Hex Bolt Assemblies.
Attach the opposite end of the Central Stringers using 5/16
x 4" Lag Screws and Flat Washers through
the Right Platform Side.
Step 12 — Angle Braces:
Fasten an Angle Brace (B) to each end of both Platform
Sides (K) using four 5/16 x 2-1/2" Hex Bolt Assemblies. Do
not tighten these bolts yet. The Angle Braces (B) should be
fastened so that the angled end is flat against the Corner
Post nearest to it.
Fasten two Angle Braces each to both the Front and Back
Platform Support (Q & R), in the positions shown, using four
5/16 x 2-1/2" Hex Bolt Assemblies. Do not tighten these bolts
yet. The Angle Braces should be fastened so that the angled
end is flat against the nearest Post.
E
AC
B
K
R
Q
K
B
Note: There will be two extra holes in both the Platform Front
and Platform Back that will not be used on the Yorktown as-
sembly. Use Hole Caps to cover the extra holes.
