Assembly
NEWBURY
19963-100 Rev C (05-20)
© Copyright 2015, Creative Playthings
Page 17
ASSEMBLY INSTRUCTIONS
STEP 23 – Hand Grips:
Fasten a Hand Grip (Z) to each Entrance Slat using two 1/4
x 1" Hex Bolt Assemblies.
Z
STEP 24 – Slide Mount:
Place the Slide Mount (I) tight against the front Platform
Support, centered on the opening for the slide. The beveled
edge of the Slide Mount should face the inside of the gym.
Secure the Slide Mount to the Platform Boards using four #8
x 2-1/2" Screws.
Drive the screws until the heads are flush with the top of the
Slide Mount. Do not over-tighten; over-tightening may cause
the points of the screws to protrude through the bottom of
the Platform Boards.
Important: Set the rails of the Rock Climber
into the ground so the Rope fastens as close
to the ground as possible.
Overhand
Knot
Figure 8
Knot
Parts omitted
for clarity.
AI
I
STEP 25 – Climbing Rope:
The Climbing Rope (AI) comes pre-knotted on approximate-
ly 12" centers. This is done to prevent the rope from sepa-
rating and it provides a better grip. Additional knots can be
added to shorten the rope. DO NOT MODIFY THE DESIGN
OF THIS ROPE. IF THE ROPE IS REPLACED, IT IS EX-
TREMELY IMPORTANT THAT YOU MAINTAIN THE SAME
DESIGN AND CONSTRUCTION.
Insert the Climbing Rope (AI) though the hole in the Rope
Tent Support. Tie a figure eight knot at the end of the rope,
inside the gym. Leave at least 2" of rope beyond the end of
the knot.
Pre-stretch the rope before tieing the bottom end. The bottom
end of the Rope MUST pass through the hole in the Rope
Board and Rope Bottom Support. Pull the Rope through the
hole until it is tight and tie a knot in the end. A figure-eight
knot is preferred, but an overhand knot can be used in the
lower position.
Check the rope periodically to ensure that it has not loos-
ened. Tighten the rope when necessary.
WARNING: AT NO TIME SHOULD THE BOTTOM END OF THE
ROPE BE UNTIED OR LOOSE ENOUGH TO FORM A LOOP.
THIS PRESENTS EXTREME DANGER TO YOUR CHILDREN.
