© Copyright 2015, Creative Playthings
NEWBURY
19963-100 Rev C (05-20)
Page 10
ASSEMBLY INSTRUCTIONS
STEP 5 – Supports to Back Frame:
Turn over the Swing End Assembly. Fasten one Side
Support (AC) to each side of the Swing End Assembly
near the bottom using two 5/16 x 4-1/2" Hex Bolt As-
semblies each as shown.
Fasten two Platform Sides
(AH) near the middle of the
Assembly using two 5/16 x
4-1/2" Hex Bolt Assemblies
each. Be sure to orient the
board so the central holes
are nearer the bottom of the
gym when assembled.
AC
AC
AH
AH
STEP 4 – Swing End Assembly:
Select the remaining two Posts with opposing Weld Nuts
and lay them out roughly 50" apart as shown at right. Fasten
one End Support (AA) to the Posts near the bottom using
four 5/16 x 4" Hex Bolt Assemblies.
A Hex Bolt Assembly consists of one Hex Bolt,
one Lock Washer, one Flat Washer and one
Weld Nut.
Fasten the Platform Back (AF) to the
Posts near the middle
using two 5/16 x 4" Hex
Bolt Assemblies. Use
the top holes at each
end of the Platform
End. Make sure the
other holes in the Plat-
form End are aligned as
shown.
Fasten the Front Tent Support (C) to
the Posts near the top using four 5/16 x 4"
Hex Bolt Assemblies. The large holes for the Tent
Pipes should face the ground. Make sure the other
holes near the center are aligned as shown; closer to
the top of the board.
No Bolt
C
AF
AA
These holes align
Fasten two remaining Side Supports
(AC) to the Swing End Assembly near the
top using two 5/16 x 4-1/2" Hex Bolt Assem-
blies each.
These holes
close to top
