8
WeedRoller PRO Owner's/Parts Manual
54678-00 R010114
ASSEMBLY & MOUNTING
2.7 REMOVING THE DRIVEHEAD
2.9 MAGNET REPLACEMENT
1. Remove the magnet arm mount by pulling it off the
pivot tube.
2. Loosen the knob located below the head unit.
3. Lift the WeedRoller PRO head unit off of the base unit.
2.8 REINSTALLING THE DRIVEHEAD
1. Slide the head unit mount sleeve back on to the base
unit. Turning of the lower gearbox output shaft may be
necessary to rotate and realign the hex shaft into the
motor coupler.
2. Tighten the knob below the head unit.
3. Snap the magnet arm mount back on to the pivot tube.
Make sure the alignment detent positions itself within
the slot on the pivot tube.
The WeedRoller PRO Pro uses a Rare-Earth type magnet
and should never weaken. If for some reason the magnet
needs replacement be sure to install it with the south pole
facing down. The south pole will be the side that has an
indication mark.
NO GAP BETWEEN
MAGNET ARM MOUNT
AND PIVOT BUSHING
DETENT LINES UP WITH
SLOT ON THE PIVOT TUBE
4. Slide the magnet arm mount down so it is in contact
with the pivot bushing. This will set the magnet at the
proper gap distance from the sensors.
2.8 REINSTALLING THE DRIVEHEAD
(CONT.)
