John Deere Air Reel Owner’s Manual
41
ASSEMBLY
Figure 54, Reinstalling reel lift cylinder
Figure 56, Stop latch
The cylinder safety lock must be shortened
(Figure 53).
Remove the safety lock from the reel arm
mount.
Measure 17.44” from the center of the pivot
bolt towards the bottom end and mark.
Cut the safety lock and reinstall onto the reel
arm mount.
Install the cylinder onto the head with the taper on the
yoke to the rear (Figure 54). Install the lower pivot pin
into the bottom hole (Figure 55).
Reposition the stop latch 1-1/4” forward on the under
-
side of the reel arm (Figure 56).
Remove the latch.
Drill two new holes 1-1/4” from the existing
holes.
Reattach the stop latch.
6.
A.
B.
C.
7.
8.
A.
B.
C.
Figure 53, Shortening the safety lock
Figure 55, Install pivot pin in bottom hole
4.19 REEL SUPPORT iNSTALLATiON (HYD. FORE AND AFT) (600 SERiES)