GALOPPINO
USAGE AND MAINTANENCE MANUAL
Manual no.
Ed.
Date
Pag.
MCA1001-EN-ED05
05
12/09/14
16/31
This document is the property of CRAMARO TS s.r.l. and cannot be reproduced, even if only partially, without the written authorisation
of the company
Pag 16
Proceed as follows to recognise and save a new remote control:
1. Press the (red) mushroom-shaped emergency button to switch the device off and
wait at least 1 second
2. Release the (red) mushroom-shaped emergency button to switch the device on
again
3. Within 3 seconds after start-up, press buttons A and D on the remote control
simultaneously until the LED will light up for about 100 ms (wait for about 3 s). This
means that the control unit has is entered the learning mode.
4. Release buttons A and D of the remote control and wait at least 1 second;
within 10 seconds, in the control unit learning mode, activate the save function
of the remote control.
5. Save the remote control code: press and hold the A button on the remote control
until the LED will be activated with two consecutive pulses of about 100 ms to
indicate that the control unit has successfully performed the function and exited the
learning mode.
Repeat the steps above to recognise and save a new remote control.
.
IMPORTANT NOTE : You can only add one remote control at a time.
Deleting from the Control Unit Memory
The control unit's memory, used to recognise the remote controls, can be erased at any time.
Proceed as follows to erase the control unit's memory:
1. Press the (red) mushroom-shaped emergency button to switch the device off and
wait at least 1 second
2. Release the (red) mushroom-shaped emergency button to switch the device on
again
3. Within 3 seconds after start-up, press buttons A and D on the remote control
simultaneously until the LED will light up for about 100 ms (wait for about 3 s). This
means that the control unit has is entered the learning mode.
4. Release buttons A and D of the remote control and wait at least 1 second;
within 10 seconds, in the control unit learning mode, activate the code delete
function.
5. Deleting codes from the memory : press and hold the A and D buttons on the
remote control simultaneously until the LED will be activated with two consecutive
pulses of about 100 ms to indicate that the control unit has successfully performed
the function and exited the learning mode.
Replacing the operating battery
Replace the battery by opening the remote control and removing the fastening screw at the back with a
screwdriver. The battery model is CR 2032
