ENglISh
Step 13: (fig. 13)
1. Attach the control assembly (Z) using two 1/4" - 1-3/4"
hex bolts (Q), four 5/16" washers (E) and two 1/4" nyloc
nuts (F).
Fig. 13
Step 14: (fig. 14)
1. Attach the end of the control rod (AL) shown below
through the slide gate bracket on the hopper.
Fig. 14
Step 15: (fig. 15)
1. Attach the other end of the control rod (AL) through the
hole in the control arm. Place a 5/16" washer (E) over
the end of the control rod and secure with a cotter pin
(G) by bending the ends out.
Fig. 15
Step 16: (fig. 16)
1. Assemble the adjustable stop (N) to the control bracket
using a 1/4" carriage bolt (B) through the stop (N) and
through the slot in the control bracket. Secure on the
other side with a nylon washer (P) and a nylon wing nut
(L). Slide the control arm grip (O) onto the control arm.
Fig. 16
Z
F
Q
E
E
AL
E
G
O
L
N
B
P
AL
