12 ― English
SETTING CUTTING HEIGHT
See Figure 10, page iii
WARNING
Do not at any time make any adjustments to
the lawn mower without first stopping the
motor and removing the safety key. Keep
your feet away from the deck when adjusting
its height.
When shipped, the rear wheels (14) on the
mower are set to a low-cutting position.
Before using the mower for the first time,
adjust the cutting position to the height best
suited for your lawn.The mower can be set to
6 cutting heights between 1.4” (35mm) and
3.4” (85mm). 6 is the highest setting,
1 is the lowest. Choose the proper cutting
height according to the types and conditions
of the grass.
To set the cutting height:
■ To raise the cutting height, grasp the
cutting height adjustment lever (13), shift it
to the side out of its position slot, and move
it toward the back of the the mower. Engage
the lever shaft into the new position slot.
■ To lower the cutting height, grasp the
cutting height adjustment lever (13), shift it
to the side out of its position slot, and move
it toward the front of the the mower. Engage
the lever shaft into the new position slot.
ASSEMBLY
locking clips and adjust the handle bar to
the middle designed position, then close the
locking clips.
To adjust height for storage:
■ Stop the mower and remove the battery
pack.
■ Unlock both locking clips, and push the
handle down as far as it will go.
■ Simultaneously press and hold both Quick
Adjust Levers and rotate the handle all the
way forward until it stops. Release levers to
secure handle in storage position.
