11 ― English
ASSEMBLY
INSTALLING THE COLLECTION BAG
See Figure 4, page ii
NOTE
: When using the collection bag, do
not install the mulching plug (17). The
mulching plug MUST be removed prior to
installing the collection bag. See Attaching/
Removing Mulching Plug section.
■ Use one hand to raise and hold the rear
safety flap (16) all the way up.
■ Lift the collection bag by its handle, and
hook the connection tips into the bag frame
holder slots.
■ Release the rear safety flap.
■ Make sure that both connection tips are
firmly seated in the holder slots and that the
rear safety flap rests firmly against the top of
the collection bag.
CAUTION
: During normal use, the bag
material is subject to wear. To reduce the risk
of injury, frequently inspect the bag assembly
and replace if there are any signs of wear or
deterioration.
INTENDED USE
This cordless lawnmower is designated for
use with Craftsman 60V Lithium-Ion batteries.
The product is intended for mowing and
mulching grass in domestic yards only. It
must not be used for mowing unusually high,
dry or wet grass, e.g. pasture grass, or for
shredding leaves. This product is intended
for private domestic use only, not for any
commercial trade use. It must not be used for
any purposes other than those described.
HANDLE TILT ADJUSTMENT
See Figures 5-7, page ii
After installing battery pack, adjust handle to
working position to operate mower.
The parking position is an intermediate
position, which is used to empty the collection
bag. Stop the machine before switching to
this position.
The storage position is used to store the
product in a space-saving manner when not
in use. Stop the machine and remove the
battery pack before switching to this position.
■ When the mower is removed from the
shipping box the handle bar is in the storage
position.
■ Simultaneously press and hold the Quick
Adjust Levers at the base of both handle
bars to release handle from storage position.
Raise the handle and rotate all the way back
into working position.
■ To pivot handle to parking position, press
the levers and push the handle forward until
it is caught by and rests against the detention
points on the handle brackets.
HANDLE BAR HEIGHT ADJUSTMENT
See Figures 8-9, page iii
To adjust the height for working:
■ Rotate handle bar into working position.
■ The mower has 2 operation height
working positions. Choose the position most
comfortable to you. To adjust the height,
grasp the handle by the top bar and pull all
the way up. You may lock the handle at this
height by closing the locking clips (4).
■ When you pull the handle all the way up,
you will notice a set of holes for the lower
height position. Lower the handle for this hole
set to be aligned with the locking clip pins.
Lock into position by closing the clips.
