Children operating or playing with a garage door
opener can injure themselves or others.
The
garage door could close and cause serious injury
or death. Do not allow children to operate the
wall push button(s) or remote control
transmitter(s).
A moving garage door could injure or kill
someone under it. Activate the opener only when
you can see the door clearly, it is free of
obstructions, and is properly adjusted.
To comply with FCC/IC rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing
the code setting or replacing the battery. THERE ARE NO
OTHER USER SERVICEABLE PARTS.
Your 18800 series garage door opener (with
receiver "SRT" button) has been factory set to
operate with the
large push button on the
transmitter(s). However, you can use either of the
two small buttons, if you prefer. And, the 3-function
transmitter(s) can also activate other garage door
openers.
Below are instructions for programming your opener
to match the other buttons on your transmitters and
any additional transmitters you may purchase. See
available accessories on page 38.
33
Your garage door opener will learn and respond to
up to 6 transmitter codes:
A. Up to 4 "SRT" portable transmitters, Item Nos.
18305, l8306 or 18307.
B. One 390MHz, 19,683 code transmitter, Item Nos.
18778 or 18779.
C. One Touch Code Transmitter, Item No.18776.
To Add A Transmitter
1. Select a transmitter push button to operate the
receiver.
2. Press and
hold the selected transmitter push
button, Figure 1.
3. Then press and release the "SRT" button on the
right side panel of the opener, Figure 2. The
opener light will
flash once.
Now the opener will operate when the transmitter
push button is pressed.
If you release the transmitter push button before
the opener light flashes, the opener will not
accept the code.
To Change the Selected Push Button
On the Same Transmitter
If you decide to use a different transmitter button
than originally programmed into the opener, you
must erase
all the learned codes and reprogram
each transmitter used to operate the garage door
opener.
To Erase All Transmitter Codes
• Press and hold the "SRT" button on the opener
panel until the indicator light turns off (about 6
seconds).
All the codes the opener has learned
will be erased.
• To reprogram, repeat Steps 1, 2 and 3 for each
transmitter in use.
Garage Door Opener Receiver
(With "SRT" Button)
"SRT"
Button
Indicator
Light
Select a transmitter push
button to operate opener
KG
KG
1
3
9
7
5
1
3
9
7
5
1
2
3
3-Function Transmitter
Push Buttons
Mini 3-Function
Transmitter
18800 Series Garage Door Openers (With "SRT" Button)
Code programming instructions are also located
on the opener panel.
WARNING
Figure 1
Figure 2
Receiver and Transmitter Programming