20
21
20
21
ASSEMBLY
For your safety, never connect plug
to power source receptacle until all
assembly and adjustment steps are
complete, and you have read and
understood the safety instructions.
ASSEMBLING THE ROLLER
WHEELS AND HANDLES TO STAND
(FIG. A, B, C)
1. Remove the bolts (2), washers (3)
and nuts (4) from the stand tube.
Insert one leg handle (1) into one
left stand tube and align the holes
on the handle and tube. Use two
bolts (2), two washers (3) and two
nuts (4) to secure the leg handle.
(Fig. A)
2. Tighten with a phillips screwdriver
and 10 mm wrench.
3. Repeat steps 1 - 2 for assembling
the other leg handle.
4. Attach one wheel (5) to the outer
side of one right stand leg using the
hex bolt (6), the sleeve (7), two flat
washers (8) and the nut (9). (Fig. B)
NOTE:
Verify that the side of the
wheel that has the concavities (10)
is facing toward the stand as shown
in Fig. B.
5. Tighten using two 17 mm wrenches
for the nut and bolt.
NOTE:
Do not overtighten. Doing so
will not allow the wheels to turn.
6. Repeat the steps 4 - 5 for
assembling the other wheel.
WARNING
!
SETTING UP THE STAND (FIG. C, D)
1. Lift the stand to its upright position.
2. Raise leg set (1) all the way up.
Then, lower the stand until leg set (1)
rests on floor.
3. Release the locking hook (2) from
the stop screw (3).
4. Step on the bottom right stand
bar (4) for leverage, grasp right
side of stand frame (7) with both
hands and pull stand up to the
highest position.
NOTE:
You should hear a "click"
sound when the stand locks
in place.
1
2
3
4
Fig. A
Fig. B
6
7
5
8
8
9
10
