page 5
5. Fan Assembly.
NOTE
: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin and
clip. Lower hanging ball and remove stop pin and
then slide hanging ball off of the downrod. [
Refer to
diagram 1
.
]
Remove vice from safety cable by loosening the screw
and nut on the vice. Loosen yoke set screws and nuts
at top of motor housing. [
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod. [
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--
make sure wires do not get twisted
. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nuts securely. [
Refer to
diagram 2
.
]
Remove canopy cover from bottom of canopy by
pushing from the inside of the canopy with a
screwdriver (not included). Slide yoke cover, canopy
cover and canopy over downrod. [
Refer to
diagram 3
.
]
Thread safety cable and wires through hanging ball
and then slide hanging ball over downrod -- the top of
the downrod should be noted as having a set screw
hole; use this hole when setting the set screw. Insert
stop pin into top of downrod and raise hanging ball.
Be sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely. [
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
["Fan Assembly" continued on next page.]
diagram 1
pin
clip
stop pin
hanging ball
set screw
diagram 4
diagram 2
set screw hole
hanging ball
stop pin
downrod
electrical wiring
yoke set screw
and nut
pin
clip
motor
housing
safety cable
motor
housing
canopy
canopy cover
downrod
yoke
cover
diagram 3
