page 8
9. Handheld Remote Control Assembly. (cont.)
Align holes in wall control with posts located
on
inside
of TOP part of remote control cover
and press together firmly. Place wall control
into BOTTOM part of remote control cover,
aligning posts in top of remote control cover
with post holes in the bottom.
[
Refer to
diagram 3
.
]
(
NOTE
: Make sure to align narrower ends of
remote control cover before closing.) Squeeze
top and bottom of remote control cover
together until you hear a click at each end,
indicating that the remote control cover has
closed completely.
wall
control
remote control
cover,
BOTTOM
post
hole
post hole
remote control
cover,
TOP
12
3
4
D
ON
O
1
2
3
4
5
6
12
3
4
D
ON
O
WALL CONTROL
(lower portion)
12
3
4
D
ON
O
DIMMER
SWITCH
CODE SWITCHES
12V BATTERY
Install one battery in handheld remote control and one in wall control (if applicable). [Batteries are included.]
IMPORTANT
: Remote/wall control will not function unless battery is installed.
CAUTION
: Store the handheld remote control away from excess heat or humidity. To prevent damage to
handheld remote control, remove the battery if not used for long periods.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR LEAK.” - When disposing of
household alkaline batteries, it is best to check with your local and state recycling or household hazardous
waste coordinators concerning the specifics of the program in your area. You may also locate a recycling
center by calling 1-800-8-BATTERY or 1-877-2-RECYCLE or visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING
:
Choking Hazard
- Small parts. Keep battery away from children.
CODE SWITCHES
&
GT LEARN
Button: With fan power OFF, set
CODE SWITCHES
on handheld remote
control and/or wall control to desired code setting. Turn fan power
on. Within 30 seconds of powering fan, press and hold
GT LEARN
button on remote control and/or wall control for 5 seconds (or until
fan beeps twice) in order to synchronize remotes with fan motor.
DIMMER SWITCH
:
Dimming capability is determined by the type of bulbs provided
with the light kit (
sold separately
).
ON position =
D
OFF position =
O
10. Automated Learning
Process./Activating Code.
GT LEARN
BUTTON
REMOTE CONTROL
(lower portion)
BATTERY
COMPARTMENT
12
3
4
D
ON
O
DIMMER
SWITCH
CODE
SWITCHES
GT LEARN BUTTON
BATTERY
COMPARTMENT
IMPORTANT:
The code switches in
remote and wall
controls MUST MATCH
for fan to function
properly.
12V BATTERY
diagram 3
