page 9
11. Testing Your Fan.
It is recommended that you test fan before finalizing installation.
Locate handheld remote control. Test fan speeds with the
different fan speed buttons (1 - 6) on handheld remote control.
Test the light ON/OFF function with the button and then test
the dimmer function by pressing the button and holding it
down for up to 5 seconds. Test wall control (optional installation)
by locating ON/OFF slider switch on wall control, then set to the
ON position. Test fan speeds and light as was done for handheld
remote control. If the wall/remote control operate(s) the functions
of the fan and light, battery (batteries) has (have) been installed
correctly. If the wall and/or remote control do (does) not operate
the fan/light functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Fan
must
be on LOW
before
setting the fan in reverse. Use the
button to recirculate air depending on the season. A ceiling
fan will allow you to raise your thermostat setting in summer and
lower your thermostat setting in winter without feeling a
difference in your comfort.
NOTE
: If the wall/remote control interferes with other appliances,
change code switches on the wall/remote control to another
code. If you do change the code,
turn power off first
. After setting
the new code on the wall/remote control, go back to the
instructions for the GT LEARN button in Section 10 (page 8).
IMPORTANT
: Remote control (and wall control, if applicable) must
be synchronized with fan in order to function properly.
10. Automated Learning Process./Activating Code. (cont.)
LED LIGHT
:
Lights up when any button is pressed.
FAN
SPEED,
Buttons
1-6
:
Use to control the ceiling fan speed 1-6.
REVERSE
Button:
Use to control fan direction.
UP-LIGHT
:
Use for up-light (if applicable;
not applicable for this fan
).
LIGHT KIT
:
Use for light kit (if applicable;
light kit sold separately
).
FAN OFF
:
Use to turn fan off.
ON
/
OFF
Slider Switch:
[
Wall control only
] Use to turn wall control on or off.
Select faceplate for remote control and/or wall control and press firmly onto front of remote control and/or wall
control.
IMPORTANT:
The Automated Learning Process takes 5 minutes to complete. Please leave the fan “on” for
the duration of the 5-minute programming and DO NOT use the remote control during this
time.
REMOTE CONTROL
FAN OFF
REVERSE
1
2
3 4
5
6
WALL CONTROL
FAN OFF
REVERSE
ON/OFF
SLIDER
SWITCH
FAN SPEED
FAN SPEED
LED LIGHT
LED LIGHT
IMPORTANT
Remote and wall
controls must be
SYNC R ONI E with
fan in order to
properly function.
FACEPLATE
BATTERY
1
2
3
4
5
6
LIGHT KIT
UP-LIGHT
