page 6
6. Wiring. (cont.)
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
*
Reorient or relocate the receiving antenna.
*
Increase the separation between the equipment and receiver.
*
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
[
PLEASE NOTE
: Wall and/or handheld remote
control must be used for fan to operate.
If you
do
not
wish to use the wall control, please
proceed to Section 7 below to continue with fan
installation.
]
To install wall control
, remove existing wall
switch. Wire one of the
wall controls with wire
connectors provided
as shown in diagram at
right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire connectors
into outlet box.
WARNING:
CONNECT WIRES IN THE
FOLLOWING ORDER ONLY!
Connect
GREEN
/
YELLOW
ground wire from
wall control to ground wire from house or
directly to one of the screws from the outlet
box.
Connect one
BLACK
wire from wall control to
BLACK
(hot) lead wire from house. Connect
second
BLACK
wire from wall control to
BLACK
load wire to fan.
Attach wall control to outlet box and secure
with screws from original wall switch. Attach
front plate to wall control using 2 screws
provided in the wall control.
black (OUT to fan)
green/yellow
black
(AC IN from
breaker box)
black
(TO POWER supply)
outlet box
wall
control
(wiring for wall control)
plate
1
2
3 4
5
6
black
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and partially loosen both screws. Lift
canopy to hanging bracket. Place rounded
part of slotted holes in canopy over loosened
screws in hanging bracket and push up. Twist
canopy to lock and then tighten both screws
securely.
hanging bracket
screw
canopy
screw
12
3
4
D
ON
O
green/
bare
ground
