page 3
3. Installation Preparation.
ON
OFF
ON
OFF
4. Hanging Bracket Installation.
Turn off circuit breakers to current fixture from breaker panel
and be sure operating light switch is turned to the OFF position.
WARNING
: Failure to disconnect power supply prior to installation
may result in serious injury.
Remove existing fixture.
WARNING
: To reduce the risk of fire, electric shock, or personal
injury, mount to outlet box marked "Acceptable for Fan Support of
22.68 kg (50lbs.) or Less" and use mounting screws provided with
the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may
need to be replaced. Consult a qualified electrician if in doubt.
When using an existing outlet box, be sure the outlet box is
securely attached to the building structure and can support the
full weight of the fan. Ensure it is clearly marked "Suitable for Fan
Support." If not, it must be replaced with an approved outlet box.
Failure to do so can result in serious injury.
CAUTION
: Be sure outlet box is grounded and that a ground wire
(
GREEN
or bare) is present.
Install hanging bracket to outlet box using original screws,
spring washers and flat washers provided with new or original
outlet box.
*
If installing on a vaulted ceiling, face opening of
hanging bracket towards high point of ceiling. Arrange
electrical wiring around the back of the hanging bracket and
away from the bracket opening.
*Note
: It is very important that you use the proper hardware when
installing the hanging bracket as this will support the fan.
10 feet
(3.05m) (76cm)
30
inches
12f
t.
- 20f
t.
12ft. - 20ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
blade edge
To prevent personal injury and damage,
ensure that the hanging location allows the
blades a clearance of 10 feet (3.05m) from the
floor and 30in. (76cm) from any wall or
obstruction.
This fan is suitable for room sizes up to
400 square feet (37.2 square meters).
Installation requires these tools:
Phillips screwdriver, flathead screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape
hanging bracket
spring washers
outlet box screws
flat washers
This fan can be mounted with a
downrod
on
a regular (no slope) ceiling
only
. The hanging
length can be extended by purchasing a
longer downrod (0.5in./1.27cm diameter). Fan
CANNOT be mounted as a flushmount NOR
on a vaulted ceiling.
downrod
installation
flushmount
installation
CANNOT be
installed on
angled or
vaulted ceilings with
downrod provided
