page 6
8. Blade Assembly.
J
motor
housing
blade
lock washers
blade arm screws
blade attachment
screws and washers
blade arm
Time Saver:
Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in one of the hardware packs. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat procedure for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (
save blade arm screws and
lock washers to secure blade arms
). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat this procedure with remaining blade
arms. Secure all screws.
Note
: Tighten blade arm screws twice a year.
Remove 3 screws from top of light kit fitter.
Remove finial, finial plate, and rubber washer
from bottom of light kit fitter.
Save finial, finial
plate, and rubber washer for later use.
Locate
BLUE
and
WHITE
wires in switch
housing labeled "FOR LIGHT KIT CONNECTION".
Remove and discard plastic that holds these 2
wires together.
Connect
WHITE
wire from switch housing to
WHITE
wire from light kit fitter. Connect
BLUE
(or
BLACK
) wire from switch housing to
BLACK
wire from light kit fitter. Make sure that molex
connections are secure.
["Light Kit Assembly" continued on next
page.]
9. Light Kit Assembly.
switch
housing
molex connections
light kit fitter
switch housing
cap
finial plate
finial
motor housing
rubber washer
plastic
motor
lock
