page 4
Install hanging bracket to outlet box using
original screws, spring washers and flat washers
provided with new or original outlet box.* Pull
electrical wiring from outlet box through center
hole in the hanging bracket.
*
Note
: It is very important that you use the proper
hardware when installing the hanging bracket as
this will support the fan.
Lift motor assembly to hanging bracket and slide
slot at one end of motor assembly over j-hook on
hanging bracket. This will allow motor assembly
to hang out of the way while wiring.
Tip
: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to below, please use a
qualified electrician.
When fan is secured in place on the hanging
bracket, electrical wiring can be made
as follows:
Connect
BLACK
and
BLUE
wire from fan to
BLACK
wire from ceiling with wire connector
provided.
Connect
WHITE
wire from fan to
WHITE
wire from
ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together
from fan to
BARE
/
GREEN
wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch, connect
BLUE
wire from fan
to the
BLACK
(or
RED
) supply from the
independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
4. Hanging Bracket Installation.
(cont.)
5. Wiring.
hanging
bracket
spring washers
outlet box screws
flat washers
hanging
bracket
j-hook
motor assembly
*
WHITE
WHITE
BLACK
BLACK
BLUE
GREEN
GREEN
wire
connector
supply circuit
WHITE
BLACK
SWITCH
outlet box
GROUND
(GREEN
OR BARE)
