page 6
9. Light Kit Assembly (Optional).
If you wish to USE the light kit
, remove 3 screws on
sides of motor plate. [
Refer to
diagram 1
]
Connect
WHITE
wire from motor
assembly
to
WHITE
wire from light kit fitter. Connect
BLACK
(or
BLUE
) wire from motor housing to
BLACK
wire
from light kit fitter. Be sure molex connections snap
together securely.
Align holes in light kit fitter with holes in motor
plate. Re-insert 3 screws that were previously
removed and securely tighten all 3 screws with
Phillips screwdriver. [
Refer to
diagram 1
]
Install one 50 watt max. halogen bulb, type JD E11
(included).
Tip
:
Do not touch glass portion of bulb with fingers or
hands. Oil from skin can cause bulb to overheat and
go out prematurely. Use cardboard box or foam
wrapping bulb was packed with to layer around glass
portion of bulb.
Locate slots on glass shade and align with nodules
inside light kit fitter. Gently push up on glass shade
and turn
to the RIGHT (clockwise)
until it slides
completely into place. Pull down gently on glass
shade to make sure glass is secured completely.
[
Refer to
diagram 2
]
IMPORTANT
:
The glass shade must be removed in
order to replace the bulb. When you need to replace
the bulb, please allow bulb and glass shade to cool
down before touching. Keep in mind not to touch
the bulb itself as described above (see "
Tip
" above).
If you do NOT wish to use the light kit
,
locate 2
holes on motor plate and align with 2 holes on
metal cover. Attach with 2 screws in one of the
hardware packs using the “Allen” wrench included.
[
Refer to
diagram 3
]
motor housing
motor plate
light kit fitter
glass shade
slot
nodules
molex connections
bulb
diagram 1
diagram 2
diagram 3
motor plate
metal cover
