page 8
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside
of motor and partially loosen the other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex plugs
from motor housing to come through hole in
middle of fitter plate. Twist fitter plate to lock.
Re-insert screw that was previously removed
and securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from LED light kit . Connect
BLACK
wire from motor housing to
BLACK
wire from
LED light kit. Be sure molex connections snap
together securely. [
Note:
If you will NOT be
using the light kit, do NOT connect the plugs.]
Carefully arrange wiring within the back of
LED light kit. Align slotted holes in LED light
kit with loosened screws in fitter plate. Twist
LED light kit to lock. Re-insert screw that was
previously removed and securely tighten all 3
screws.
Locate slots on glass shade and align with
nodules on inside of LED light kit.
Gently push
up on glass shade and turn
to the RIGHT
(clockwise)
until glass shade locks into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
CAUTION
: D
o
not
connect the LED light kit if
you do NOT wish to use the light.
glass shade
fitter plate
motor plate
motor housing
molex
connections
nodules
slots
fitter plate
LED light kit
LED light kit
screws
molex
connections