page 11
Fan
SPEED
control buttons
1
:
Use to control the ceiling fan speed 1-6
Fan
OFF
button
2
:
Use to turn the fan off
REVERSE
function button
3
:
Use to control fan direction
LIGHTING
button
4
:
Use to control down-light and up-light (if applicable)
ON
/
OFF
slider switch
5
:
[Wall control only] Use to turn wall control on or off
IMPORTANT:
Handheld remote
control and wall
control must be
SYNCHRONIZED with
fan in order to
properly function.
handheld
remote control
wall control
4
3
1
5
I
OFF
ON
II
III IV
V
VI
2
12. Remote/Wall Control Operation.
I
II
IV
VI
III
V
4
1
2
3
13. Testing Your Fan.
It is recommended that you test fan before finalizing installation. Restore power
from circuit box and light switch (if applicable). Test wall control (optional
installation) by locating ON/OFF slider switch on wall control, then set to the ON
position. Test light function and test fan speeds. Locate handheld remote control.
Test fan speeds with the different fan speed buttons (
I - VI
) on handheld remote
control. Test the light ON/OFF function by pressing the button. If the remote
control operates all of the functions of the fan, battery has been installed correctly.
If the wall and/or remote controls do (does) not operate all of the fan functions,
refer to "Troubleshooting" section to solve any issues before contacting Customer
Service.
Fan
must
be on LOW
before
setting the fan in reverse. Use button to
recirculate air depending on the season. A ceiling fan will allow you to raise your
thermostat setting in summer and lower your thermostat setting in winter
without feeling a difference in your comfort.
NOTE
: If the wall control/handheld remote control interferes with other
appliances, activate a new code on the wall control/ handheld remote control by
turning the power off first
. Go back to the instructions for the SET button in
Section 11 (page 10).
IMPORTANT
: Handheld remote control and wall control must be synchronized
with fan in order to properly function.
I
II
IV
VI
III
V
I
OFF
ON
II
III IV
V
VI
IMPORTANT
:
The Automated Learning Process takes approximately 5 minutes to complete.
Please
leave the fan “ON”
for the duration of the 5-minute programming and
do NOT use
the
remote control or turn off the power
during this time.
The fan will
cycle through ALL SIX (6) speeds in forward and reverse
and will
then stop
automatically
after the learning process is complete.
