page 9
dimmer
switch
wall control
wire
wire
wire
1
1
-
2
2
-
ON/ DIM
OFF
12V battery
10. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10 for
remote control assembly instructions. If you have
already installed the wall control but do
not
wish to
use the handheld remote control, please proceed to
Section 11.
Gently pull on remote control cover to separate
top and bottom parts.
[
Refer to
diagram 1
.
]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was not
previously used)--use wire cutters to cut off each
wire as close to the wall control as possible.
[
Refer
to
diagram 2
.
]
Install one 12-volt battery (included) in wall
control.
[
Refer to
diagram 2
.
]
The dimmer switch (labeled
DIM
and
ON/OFF
)
has been pre-set to the "ON" position (
DIM
). If you
do not wish to have dimming capability, please
move the switch to the "OFF" position (
ON/OFF
).
[
Refer to
diagram 2
.
]
Attach
black faceplate
to front of wall control;
press down firmly.
[
Refer to
diagram 3
.
]
Align holes in wall control with posts located on
inside
of TOP part of remote control cover and
press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom.
[
Refer to
diagram 3
.
]
(
NOTE
: Make sure to align narrower ends of
remote control cover before closing.) Squeeze top
and bottom of remote control cover together until
you hear a click at each end, indicating that the
remote control cover has closed completely.
IMPORTANT
: Store the remote control away from
excess heat or humidity. To prevent damage to
remote control, remove the battery if remote
control will not be used for long periods.
(top)
(bottom)
remote
control
cover
1
1
-
2
2
-
ON/ DIM
OFF
wall
control
face-
plate
remote control
cover,
BOTTOM
post
hole
diagram 1
diagram 2
diagram 3
post
hole
remote control
cover,
TOP
