page 7
7. Canopy Assembly.
8. Blade Assembly.
Time Saver
: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor housing, aligning holes
in blade with holes in blade arm (
located on
the underside of the motor housing
)--
refer
to drawing at right
. Insert 3 blade attachment
screws (along with washers) with fingers first
and then tighten screws securely with a
Phillips screwdriver. Repeat procedure for
each remaining blade.
Note
: Tighten blade attachment screws
twice a year.
blade
motor housing
blade attachment
screws and washers
blade
arm
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely.
Slide canopy cover up to canopy, aligning rounded part
of slotted holes in canopy cover with screw heads in
bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
hanging bracket
screw
screw
canopy cover
canopy
