2
Step 2 - Blade Assembly
Take out the four screws in the Top Motor Housing (#4). Save the
screws. Raise the Top Motor Housing (#4) off the base (see figure 1).
Slide blade (#5) through slot on side of fan. Attach with Blade Screws
(S4) as shown in figure 2. Repeat this procedure until all five blades are
secured. Tighten firmly. Top Motor Housing will be reattached in
following step.
Figure 1
Motor Housing (#4)
Top Motor Housing (#4)
CAUTION:
Never hold or lift fan by blades
Figure 2
Blade Screws (S4)
Top View
Prior to securing Mounting Bracket/Plate, screw "J" Hook (S8) into
Ceiling Outlet Box as a secondary support means. Secure mounting Plate
(1A) to the outlet box (A) by tightening Bracket Screws & Washers (S3)
as shown. If not mounting to an outlet box, use wood screws (S1) and
washers (S1) and mount securely to ceiling beam. Be sure at this point to
insert Canopy Screws (S2) in bracket.
NOTE:
Do not mount directly to sheet rock or ceiling tile.
NOTE:
J Hook installation is a Canadian requirement only.
1
OUTLET BOX
Outlet Box (A)
Support Beam
Ceiling
“J” Hook (S8)
Mounting Plate (1A)
Bracket Screws
& Washers (S3)
Wood Screws (S1)
Ground Wire
Helpul Hint
Remove fan motor (#4) from inside the box, turn the top foam insert
upside down, then lay the fan motor face down into the foam. This
will hold the motor housing steady during assembly.
Step 1 -
Flushmount Option
