page 7
7. Wiring.
WARNING
: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION
:
Be sure outlet box is properly grounded and that
a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the diagram to the right, please use a
qualified electrician.
Note
:
Excess lead wire length from the fan can be cut to the
desired length and then stripped.
When downrod is secured in place on the hanging
bracket,
WIRE THE RECEIVER
with wire connectors
provided
as shown in diagram at right.
Tip
: While you are wiring, keep in mind that wires must
not obstruct receiver from sliding into hanging bracket.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging bracket
and carefully push taped wire connectors into outlet
box. Let antenna rest
outside
of hanging bracket.
[
PLEASE NOTE
: Wall or handheld remote control must
be used for fan to operate.
If you do
not
wish to use the
remote as a wall control, please proceed to Section 8 to
continue with fan installation.
]
To install remote control as wall control
, remove
existing wall switch. Wire the
remote control with wire
connectors provided
as shown in diagram at right.
*Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires and
taped wire connectors into outlet box.
Install one 12-volt battery (included) in remote control.
IMPORTANT
: Remote control will not function unless
battery is installed.
Since this fan comes with a LED light kit, the dimmer
switch (labeled
DIM
and
ON
) has been pre-set to the
"ON" position (
DIM
). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (
ON
).
Select a faceplate (almond or white) and press firmly
onto front of control. Attach control to outlet box and
secure with screws from original wall switch. Attach
plate (included) tocontrol using 2 screws provided.
(wiring for receiver)
ground (green
or bare)
white supply wire
black supply wire
black
black
white
blue
blue
white
from receiver
black
AC IN L
AC IN N
white
whit
e
ground (green
or bare)
from fan
from receiver
antenna
from ceiling
receiver
black
*
(wiring for wall control)
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
remote
control
face-
plate
12V battery
dimmer
switch
plate
1
1
-
DIM ON
WARNING
:
Choking Hazard
- Small parts.
Keep battery away from children.
