reverse switch
page 10
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable). Test
wall control (optional installation) by locating ON/OFF slider switch
on wall control, then set to the ON position. Test light and dimmer
function and then test fan speeds. Next, locate handheld remote
control. Test the light ON/OFF function by pressing the L1 button;
test the dimmer function by pressing the L1 button and holding it
down for 1 second. Test fan speeds with the different fan speed
buttons. If the wall or handheld remote control operates all of the
functions of the fan, battery has been installed correctly. If the wall
or handheld remote control does not operate all of the fan/light
functions, refer to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off
before
moving the reverse switch (located
under the yoke cover on the motor housing). Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (
diagram 1
)
- RIGHT position in winter (
diagram 2
)
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without feeling
a difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for fan to function. If the reverse switch is
set in the
middle
position (
diagram 3
), fan will not operate.
NOTE
: If the wall control or handheld remote control interferes with
other appliances, follow instructions in Section 13.
12. Testing Your Fan.
11. Remote Control Operation.
ON/OFF
slider switch - turns
wall control
ON or OFF
(switch not functional on handheld remote)
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L1
button -
turns
light kit
ON/OFF when pressed once;
dims
light kit
when pressed and held down
wall control
handheld
remote control
1
1
-
diagram 1
diagram 2
diagram 3
1
1
-
1
1
-
13. Re-syncing Fan and Remote.
If it becomes necessary to re-sync your fan and wall control/handheld remote control:
If using the wall control,
turn power off and then on. Set slider switch on wall control to the ON position.
Within 60 seconds of turning on the wall control, press and hold the fan
OFF
button on the wall control for 5
seconds or until light blinks twice or blades begin to turn.
If using the handheld remote control,
turn power off for at least 5 seconds and then turn power back on.
Within 60 seconds of restoring the power, press and hold the
OFF
button on the front of the handheld remote
control for 5 seconds or until light blinks twice or blades begin to turn.
Test the light and fan functions to confirm the fan and wall control or handheld remote control are synced.
See
Section 11 for “Remote Control Operation.”.
