4. Hanging Bracket Installation.
page 4
ON
OFF
ON
OFF
3. Installation Preparation.
To prevent personal injury and damage, ensure that
the hanging location allows the blades a clearance
of 7ft. (2.13m) from the floor and 30in. (76cm) from
any wall or obstruction.
This fan is suitable for room sizes up to
400 square feet (37.2 square meters).
This fan can be mounted as a
flushmount
on a regular (no-slope) ceiling
only
.
Downrod
installations are
not
available for this fan.
downrod
installation
flushmount
installation
CANNOT be
installed on
angled or
vaulted ceilings
Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch is
turned to the OFF position. [
Refer to
diagram 1.
]
WARNING
: Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING
: When using an existing outlet box, be sure
the outlet box is securely attached to the building
structure and can support the full weight of the fan.
Ensure outlet box is clearly marked "Suitable for Fan
Support." If not, it must be replaced with an approved
outlet box. Failure to do so can result in serious injury.
CAUTION
: Be sure outlet box is grounded properly and
that a ground wire (
GREEN
or bare) is present.
Remove 4 motor mounting nuts and flat washers
from hanging bracket--
save for later use.
[
Refer to
diagram 2.
]
Install hanging bracket to outlet box using original
screws, spring washers and flat washers provided
with new or original outlet box.* Install rubber
cushions between outlet box and hanging bracket (if
not already pre-attached to hanging bracket) to
reduce vibration of metal to metal surfaces. Pull
electrical wiring from outlet box through center hole
in the hanging bracket. [
Refer to
diagram 3.
]
*
Note
: It is very important that you use the proper
hardware when installing the hanging bracket as this
will support the fan.
flat
washers
motor
mounting
nuts
hanging bracket
blade edge
7 feet
(2.13m)
(76cm)
30
inches
hanging bracket
spring washers
outlet box screws
flat
washers
rubber cushions
diagram 1
diagram 2
diagram 3
12f
t. - 20f
t.
12ft. - 20ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
