page 8
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed, and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screw
heads in bottom of canopy. Turn cover to the right
(clockwise) until it stops.
hanging bracket
screw
canopy
screw
canopy cover
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and
break.
Locate 5 blade plates and 15 blade
attachment screws/washers in hardware
packs. Slide blade through one of the
narrow, rectangular openings on motor
housing, aligning holes in blade with
holes in blade arm (
located on the
underside of the motor housing
)--refer
to drawing at right. Hold 1 blade plate up
to a blade, placing the flat side of the
blade plate against the blade, and align
holes as shown. Insert 3 blade attachment
screws/washers with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for
remaining blades.
NOTE
: Tighten blade attachment screws
twice a year.
blade
blade attachment
screws/washers
blade
arm
motor
housing
blade plate
