page 6
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed and then
tighten both screws securely. Slide canopy cover
up to canopy, aligning rounded part of slotted
holes in canopy cover with screwheads in bottom
of canopy. Turn canopy cover to the right
(clockwise) until it stops.
8. Blade Assembly.
Time Saver:
Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware packs. Hold blade arm
up to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat procedure
for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor and if needed, locate the
others in one of the hardware packs. If plastic
motor locks are installed with blade arm
screws, discard plastic motor locks (
save blade
arm screws/lock washers to secure blade arms
).
Align blade arm holes with motor screw holes
and attach blade arm with blade arm
screws/lock washers. Before securing screws
permanently, repeat procedure with
remaining blade arms. Secure all screws.
Note
: Tighten blade arm screws twice a year.
screw
canopy
hanging
bracket
screw
canopy cover
blade arm screws
lock washers
motor housing
blade arm
blade
blade attachment
screws and washers
plastic
motor lock
