7
Step 7
For added security, attach safety cable from fan unit to "J" hook (S10) in
outlet box. Secure by looping zip tie (S11) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (1).
Turn housing until hanging ball seats itself into ball socket (listen for click).
NOTE
: Parts furnished will allow
you to install your fan at up to a 35
°
angle. Angles greater than 35
°
will
require a 45
°
angle adapter (see
dealer).
NOTE
: J Hook installation
is a Canadian requirement only.
Outlet Box (A)
Support Beam
Ceiling
Green Ground Wire
“J” Hook (S10)
OUTLET BOX
“J” Hook (S10)
Safety Cable
Zip Tie (S11)
Mounting Bracket (1)
WARNING:
To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be replaced.
Consult a qualified electrician if in doubt.
6
Step 6
Position downrod so the hole in the downrod aligns with the hole in the
coupling on the motor. Insert safety bolt (S8) through coupling and downrod
and attach nut. Tighten firmly. Tighten set screw "A" against downrod. Place
flange cover (5) over downrod assembly until it covers flange. Place canopy
(3) over downrod (2). Replace hanging ball, insert hanging pin through
downrod and tighten set screw "C" in hanging ball into downrod.
NOTE:
Flange cover will not work with supplied 2 1/2 inch downrod. Flange cover is
decorative and will not affect the operation of the fan.
Ground
Wire
Ball
Screw
Hanging
Pin
Hanging
Ball
Threaded
Set Screw Hole
WARNING:
Failure to completely tighten downrod as described in steps 5 & 6 above could
result in the fan loosening and possibly falling.
Set Screw (A)
Canopy (3)
Set Screw (C)
Downrod (2)
Flange Cover (4)
Safety Bolt & Nut
Motor Housing (7)
