Operation Instructions
1. The sequence of operation for the motor pull/chain switch is OFF-HI-
MED-LOW.
2. Push the slide switch RIGHT for FORWARD, and LEFT for REVERSE
action of the blades.
3. The pull chain switch for the lighting is two positions - ON/OFF.
4. The pull chain switch for the uplighting is on/off.
14
CAUTION:
Even if your fan is mounted with the blades more than 7 feet from the floor,
be careful to avoid placing your raised arms or any object in the path of the blades.
Motor Pull Chain
Light Pull Chain
Slide Switch
Side Light Pull Chain
13
Optional Light Kit Installation
Remove three screws from side of switch hub (as shown in figure below).
Remove hub cover from hub and pop out center plug. Carefully thread
wires from light kit through the center hole in hub cover. At this point
attach light kit into hub cover by screwing center all-thread from light kit
into the center hub cover. Lock the all-thread in place on the inside of the
hub using the 3/8" nut provided. Attach white wire from light kit to white
wire in hub, using wire nuts. Next, attach black wire from light kit to blue
wire in switch hub. Carefully push wires up into hub and replace hub cover
using screws removed earlier.
Screws
Switch Hub
Center Hole
Center Screw
Remove Finial
