Setting Frequency Switches
The remote control unit is operated by a set of frequency switches and are
preset at the factory. The switches are located in the back of the remote
control unit and in the lower part of the fan on the receiving module. The
switches can be set in any position as long as both the remote control unit
and receiving module switches are set the same. All (RF) modules &
Transmitters come from the factory with the dip switches set in the (ON)
position.
To replace battery, simply push down on tab and slide housing cover off.
Snap 9-Volt battery onto wire terminal and replace into remote housing.
Slide housing cover back onto remote control unit.
1 2 3 4
ON
Remote
Control Unit
Battery
Terminal
PUSH
Housing
Cover
1 2 3 4
ON
Remote
Housing
11
Step 11
First install Halogen Bulb by screwing bulb into socket. Install Light Kit
Assembly or Blank Cover by aligning slots on light kit/fan cover to dimples
on Light Assembly Housing. Turn glass or cover clockwise to lock securely
in place.
NOTE: Hold fan motor housing while turning light kit/cover to ensure proper installation.
Light Kit Assembly or
Blank Cover
Slots
Dimples
Light Assembly Housing
Halogen Bulb
12
Electrical Connections
Connect black fan wires to black outlet wire. Connect white fan wire to
white outlet wire and green grounding lead wire from the grounding
conductor to the supply circuit
(see figure A). Use wire
connectors provided with your
fan. No loose strands or loose
connections should be present.
Turn splices upward and carefully
push all wiring into outlet box.
When wall switches are employed,
switches should be UL listed for use
with ceiling fan.
CAUTION:
Always turn off power at breaker before
attempting any wire connections.
Ground
Black
White
Black
White
Green
