Step 1
Turn off circuit breakers and wall switch to the fan
supply line leads.
Warning:
Failure to disconnect power supply prior to
installation may result in serious injury or death.To reduce
the risk of shock, this fan must be installed with an
isolating wall control/switch.
1
Step 3
Check to make sure blades are at
least 30” from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
3
84”
(2.1m)
Min.
30”
0.75m
Min.
Preparation
Important:
When using an existing outlet box, be sure the box is securely attached
to the building structure and can support the full weight of the fan. Failure to do
so can result in serious injury or death.
Step 2
Determine mounting method to use.
A. Downrod Mount
B. Angle Mount
Craftmade Part #45AD (see dealer)
2
IMPORTANT:
If using the angle mount
method, check to make sure the ceiling angle
is not steeper than 35
°
. Angles greater than
35
°
will require a 45
°
angle adapter.
Downrod Installation
(Vaulted Ceilings)
Downrod Installation
(Normal Ceilings)
Step 4
Prior to securing mounting bracket, screw "J" hook (S7) into ceiling outlet
box as a secondary support means. Secure mounting bracket (#1) to the
outlet box (A) by tightening bracket screws & washers (S3) as shown. If
not mounting to an outlet box, use wood screws (S1) and washers (S3) and
mount securely to ceiling beam.
Be sure at this point to insert canopy
screws (S2) in bracket.
NOTE:
Do not mount directly to sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
4
OUTLET BOX
Outlet Box (A)
Mounting Bracket (1)
Bracket Screws
& Washers (S3)
Support Beam
Wood Screws (S1)
Canopy Screws (S2)
Ceiling
Wood Screws (S1)
“J” Hook (S7)
Fan Motor Housing
Hanging Ball
Lock Pin
Downrod
Ball Screw
Green Ground
Wire
Downrod
Assembly
(#2)
5
Step 5
Locate downrod assembly
(2). Loosen ball screw on
black hanging ball to free
lock pin. Black hanging
ball will slide down.
Remove ground screw and
green ground wire.
Remove hanging ball from
downrod and save all
parts. Insert fan wires
through downrod. Screw
downrod into top of fan
motor housing, being
careful that wires are
pulled through.
