switch housing
black wire
black wire
white wire
white wire
page 8
10. Light Kit Assembly (Optional). (cont.)
Connect
WHITE
wire from switch housing to
WHITE
wire from light kit fitter. Connect
BLACK
(or
BLUE
)
wire from switch housing to
BLACK
wire from light kit
fitter. When making the connections, use wire
connectors that were previously removed.
Note
: Wrap each wire connector separately with
electrical tape as an extra safety measure.
Attach light kit fitter to switch housing with 3 screws
that were removed on previous page. Tighten all 3
screws with a Phillips screwdriver.
Secure 4 glass shades using thumbscrews provided in
one of the hardware packs.
Do NOT overtighten
thumbscrews as glass may crack or break.
Install 4 candelabra base 40 watt max. bulbs included.
Important
: When replacing bulbs, please allow bulb
and glass shade(s) to cool down before touching
them.
motor housing
glass
shade
light kit
fitter
pull chain
extension
thumb
screws
11. Testing Your Fan.
pull chain
extension
thumb
screw
reverse switch
bulb
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and wall
switch (if applicable). Test fan speeds with the pull chain
on the switch housing. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will re-set the fan to OFF setting. Test
lights
with the pull chain in the middle. (
Refer to
diagram 1
.
)
If fan and/or lights do (does) not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off
before
moving the reverse switch.
Set reverse switch to recirculate air depending on the
season:
- DOWN position in summer (
diagram 2
)
- UP position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting in
winter without feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely
UP
or
completely DOWN
for fan to function. If the reverse
switch is set in the
middle
position (
diagram 4
), fan will
not operate.
Pull chain extensions supplied or custom pull chain
extensions (sold separately) may be attached to the ends
of the pull chain.
diagram 2
diagram 3
diagram 4
diagram 1
