page 7
9. Blade Assembly.
10. Light Kit Assembly (Optional).
light kit
fitter
If you wish to use your fan WITHOUT a light kit:
Remove 3 screws from switch housing cap. Be sure
that wire connectors are secure and then tape each
wire connector separately with electrical tape. Align
holes in switch housing cap with holes in switch
housing. Use screws that were just removed to
attach switch housing cap to switch housing.
Please proceed to Section 11 on the following page
to complete installation
without
light kit.
If you wish to use your fan WITH a light kit:
Remove 3 screws from light kit fitter.
Locate
BLACK
(or
BLUE
) and
WHITE
wires in the
switch housing labeled FOR LIGHT. Remove and
discard plastic that hold these 2 wires together.
Remove wire connectors from the same 2 wires as
well--save wire connectors for later use.
Next, locate
WHITE
and
BLACK
(or
BLUE
) wires in
light kit fitter labeled FOR LIGHT KIT CONNECTION.
["Light Kit Assembly" continued on next page.].
blade arm
screws
black wire
white wire
motor housing
switch housing cap
switch
housing
black wire
white wire
Time Saver:
Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are installed
with blade arm screws, discard
plastic motor blocks
(save blade arm screws and lock washers to secure
blade arms)
. Align blade arm holes with motor
screw holes and attach blade arm with screws and
lock washers. Before securing screws permanently,
repeat this procedure with remaining blade arms.
Securely tighten all screws.
Note
: Tighten blade arm screws twice a year.
motor housing
blade arm
blade
blade attachment
screws and washers
lock washers
plastic
motor
block
