3. Installation Preparation.
4. Hanging Bracket Installation.
Turn off circuit breakers to current fixture from breaker
panel and be sure operating light switch is turned to the
OFF position.
WARNING:
Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING:
When using an existing outlet box, be sure the
outlet box is securely attached to the building structure and
can support the full weight of the fan. Ensure the outlet box is
clearly marked "Suitable for Fan Support." If not, it must be
replaced with an approved outlet box. Failure to do so can
result in serious injury.
CAUTION
: Be sure outlet box is grounded properly and that a
ground wire (
GREEN
or bare) is present.
Partially loosen screws in slotted holes of canopy. Remove
the other 2 screws (along with lock washers)--
save for later
use
. Twist canopy to remove hanging bracket.
Install hanging bracket to outlet box using original screws,
spring washers and flat washers provided with new or
original outlet box.
*
If installing on a vaulted ceiling, face
opening of hanging bracket towards high point of ceiling.
Arrange electrical wiring around the back of the hanging
bracket and away from the bracket opening.
page 3
To prevent personal injury and damage, ensure that the
hanging location allows the blades a clearance of 7ft.
(2.13m) from the floor and 30in. (76cm) from any wall or
obstruction.
This fan is suitable for room sizes up to 400 square feet
(37.2 square meters).
This fan can be mounted with a
downrod
on a regular
(no-slope) or vaulted ceiling. The hanging length can be
extended by purchasing a longer downrod
(0.5in./1.27cm diameter).
After installing hanging
bracket,
c
ontinue to Section 5 on page 4 for those
instructions.
This fan can also be mounted as a
flushmount
only
on a regular (no-slope) ceiling.
After installing hanging bracket, continue to Section 6 on
page 5 for those instructions.
Vaulted ceiling
angle is not to
exceed 25 degrees.
downrod
installation
ON
OFF
ON
OFF
blade edge
7 feet
(2.13m)
(76cm)
30
inches
*Note
: It is very important that you use the proper hardware
when installing the hanging bracket as this will support the fan.
flushmount
installation
12f
t.
- 20f
t.
12ft. - 20ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
hanging bracket
spring washers
outlet box screws
flat washers
Installation requires the following tools:
Phillips screwdriver, flat-head screwdriver, adjustable
pliers or wrench, stepladder, wire cutters, and rated
electrical tape.
