page 4
5. Fan Assembly (with downrod).
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Then slide hanging ball off downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
housing.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread electrical wires through threaded end of
downrod and pull extra wire slack from the upper
end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--
make sure wires do not get twisted
.
Re-insert pin and clip previously removed. Tighten
yoke set screws and nuts securely.
[
Refer to
diagram 2
.
]
Slide canopy over downrod.
[
Refer to
diagram 3
.
]
Thread wires through hanging ball; then slide
hanging ball over downrod--the top of the
downrod should be noted as having a set screw
hole; use this hole when setting the set screw.
Insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely.
[
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw completely
could result in the fan becoming loose and
possibly falling.
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
diagram 2
diagram 1
diagram 3
diagram 4
canopy
motor
housing
downrod
downrod
electrical wiring
yoke set
screw
and nut
pin
clip
set screw
hanging ball
stop pin
pin
clip
set screw hole
hanging
ball
stop pin
