page 6
6. Fan Assembly (flushmount). (cont.)
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over the
hanging bracket tab. (Use one of the non-slotted
holes on the rim of the canopy to do so.) [
Refer to
diagram 3
.
]
canopy
motor housing
hanging bracket
tab
7. Wiring.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code.
If you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to below, please use a qualified electrician.
Note:
Excess lead wire length from the fan can be cut
to the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect
BLACK
and
BLUE
wire from fan to
BLACK
wire from ceiling with wire connector provided.
Connect
WHITE
wire from fan to
WHITE
wire from
ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together from
fan to
BARE
/
GREEN
wire from ceiling with wire
connector provided.
If you intend to control the fan light with a separate
light switch, connect
BLUE
wire from fan to the
BLACK
(or
RED
) supply from the independent
switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote control
sold separately).
black
black
white
white
blue
black supply wire
ground
(green
or bare)
white supply wire
*
from
ceiling
from
fan
ground
(green or bare)
8. Canopy Assembly.
Raise canopy to hanging bracket, aligning
loosened screws in hanging bracket with slotted
holes in canopy. Twist canopy to lock. Re-insert
screws (with star washers) that were previously
removed (on page 3, Section 4) and then secure
all screws with a Phillips screwdriver.
canopy
hanging bracket
slotted
hole
diagram 3
