page 7
8. Canopy Assembly.
canopy
Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket
align with
slotted
holes in canopy, and then lower
canopy and
partially loosen
these 2 screws.
Remove
the
other
2 screws and set aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in the canopy with
loosened screws in hanging bracket. Twist canopy
to lock. Re-insert the other 2 screws and star
washers and secure all screws with Phillips
screwdriver.
Align arrow on canopy ring with the arrow on the
canopy. Next, raise the canopy ring over the
canopy until it is even with the top of the canopy.
Make sure the canopy and the canopy ring fit
securely.
hanging bracket
slotted
hole
9. Blade Assembly.
Locate motor screws and lock washers in
hardware pack. Align pin and 2 holes in blade
arm with corresponding holes in motor plate.
Partially insert 2 motor screws (and lock
washers)
and then
tighten both scews securely.
Repeat with remaining blade arms.
Locate 9 blade attachment screws and fiber
washers in hardware packs. Align blade holes
with posts on blade arm. Insert 3 blade
attachment screws (along with fiber washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat for
the remaining blades.
[”Blade Assembly" continued on next page.]
blade attachment
screws and fiber washers
blade arm
blade
motor screws and
lock washers
motor plate
pin
post
blade arm
canopy
ring
canopy
arrow
arrow
