page 6
Attach safety cable per instructions in last
paragraph of Section 5, page 5.
canopy
motor housing
7. Wiring.
WARNING
: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
Note
:
Excess lead wire length from the fan can be
cut to the desired length and then stripped.
Once fan has been temporarily hung on the
mounting plate (
refer to drawing at right)
, or
when downrod is secured in place on the
hanging bracket, electrical wiring can be made
as follows:
Connect
BLACK
and
BLUE
wires from fan to
BLACK
wire from ceiling with wire connector
provided.
Connect
WHITE
wire from fan to
WHITE
wire
from ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together
from fan to
BARE
/
GREEN
wire from ceiling with
wire connector provided.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
(wiring for fan)
*
6. Fan Assembly (flushmount). (cont)
To prepare the fan for wiring, hang fan onto
mounting plate by sliding the canopy over the
"J" hook on the mounting plate. (Use one of
the non-slotted holes on the rim of the canopy
to do so.)
"J" hook
mounting plate
black supply wire
white supply wire
ground
(green or bare)
black
white
black
white
blue
from fan
from
ceiling
wire
connector
ground
(green
or bare)
