11. Light Kit Assembly.
Remove 1 screw from motor plate (on underside
of motor) and partially loosen the other 2 screws.
Align slotted holes in fitter plate with loosened
screws in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate. Twist fitter
plate to lock. Re-insert screw that was just
removed and tighten all 3 screws securely.
Partially loosen 3 screws on underside of fitter
plate.
Connect
WHITE
wire from motor housing to
WHITE
wire from light kit fitter. Connect
BLACK
(or
BLUE
) wire from motor housing to
BLACK
wire from light kit fitter. Be sure molex
connections snap together securely.
Carefully arrange wiring within light kit fitter.
Align slotted holes in light kit fitter with
loosened screws in fitter plate. Twist light kit
fitter to lock. Secure all 3 screws with a Phillips
screwdriver.
Install 3 candelabra base 40 watt max. bulbs, size
CA8 recommended (included).
IMPORTANT
: When replacing bulbs, please allow
bulbs and glass shade to cool down before
touching.
Remove finial, finial plate and threaded washer
from threaded rod at bottom of light kit fitter.
Align threaded rod with hole in middle of glass
shade and push up gently allowing threaded rod
to come through hole. Secure glass shade with
threaded washer.
NOTE
: Do NOT overtighten
threaded washer
as
glass may crack or break.
Align hole in center of light kit cage with
threaded rod and push up. Re-attach finial plate
and secure with finial.
NOTE
: Do NOT overtighten
finial
as glass may
crack or break.
motor
housing
light kit fitter
bulb
page 8
fitter
plate
motor plate
molex
connections
motor
housing
glass shade
finial
finial plate
threaded washer
light kit cage
threaded rod
