Crafco SS60-Diesel, Руководство пользователя

Страница: 61 / 119

Super Shot 60 Diesel Melter Part Manual
Chapter 8 Troubleshooting
©2016 by Crafco, Inc. All Rights Reserved
………………...………………………………..……………...Troubleshooting 8-13
Note : Use Figure 8.5 Mixer Circuit Schematic while troubleshooting the mixer electrical system.
Step Possible Cause If . . .
1 Is the amber light "ON" on the Din Plug when
the "Mixer" toggle switch is in the "Forward"
position? (For forward din plug location, refer
to
Figure 8.7 Din Plug Layout ).

Yes, then the mixer should be working. If it
is not working see Table 8-18 Mixer
Hydraulic Troubleshooting.

No, go to Step 1a.
1a Unscrew the din plug center screw so you
can pull the din plug up about 1/4" in order to
check for voltage.
Is there 12Vdc from side post to side post?

Yes, the electrical system for the agitator is
working properly, go to Table 8-18 Mixer
Hydraulic Troubleshooting. Also replace
din plug at earliest convenience to retain
visual troubleshooting ability.

No, go to Step 2.
2 Is there 12Vdc between the "Mixer" toggle
switch bottom post brown wire and nearby
ground wire (blue wire)? (With the "Mixer"
toggle switch in the "Forward" position.) See
Figure 8.5 Mixer Circuit Schematic.

Yes, replace din plug.

No, go to Step 2a.
2a Is there 12Vdc between the "Mixer" toggle
switch center post red wire and nearby
ground source (blue wire)?

Yes, replace mixer toggle switch.

No, go to Step 3.
3 Is there 12Vdc between the lid switch red
wires and a nearby ground source?
(Check both red wires on the bottom of the lid
switch with the lid closed.)

Yes, on both red wires check for loose
connections or broken wires between lid
switch and mixer toggle switch.

Yes, on only one red wire when the lid is
closed. Readjust the lid switch so that the lid
completely depresses the switch, and then
recheck for 12Vdc. If the same result
happens, replace the lid switch.

No, go to Step 4.
4 Check for 12Vdc at red wire labeled Red Lid
and pink wire labeled Pink-2 on terminal
block and a nearby ground source (black
wire).

Yes on both, check for loose connections or
broken wires between lid switch and
terminal block.

No on Red Lid and Yes on Pink-2, ensure
yellow jumper bar is securely installed
between the two terminal blocks.

No, go to Step 4a.
Table 8-15 Mixer Electrical Troubleshooting