Crafco MODEL 30 PAVEMENT ROUTER, Инструкция по эксплуатации и запасным частям

Страница: 19 / 63

19
OPERATING PROCEDURE (Continued)
MODEL 30 PAVEMENT ROUTER
NOTE: DUST CONTROL ROUTER OPERATING PROCEDURES CONTINUED
15. To empty the large particle dust collection bin, reduce engine speed to idle. Support the
bottom of the large particle dust collection bin with one hand, keeping the large particle
dust collection bin pressed up firmly against the mounting bracket. With your other
hand, unlatch the rubber latches on the large particle dust collection bin.
CAUTION:
(The large particle dust collection bin weighs approximately 30 lbs when full)
Dump the large particle dust collection bin in a larger receptacle where it
can be disposed of properly at a later time. Reattach the large particle dust collection
bin to the mounting bracket. Return engine to high speed and continue routing.
16. While the engine is at idle during the previous step, gently shake or lightly tap sides of
the dust collection bag with your hand.
NOTE: During router operation, what dust isn’t spun out by the cyclone, enters the dust
collection bag. This dust forms a “Dust Cake” on the inside wall of the dust
collection bag and will restrict the amount of air that can escape through the dust
collection bag, reducing the overall suction of the system. Tapping on the side
of the dust collection bag will knock this dust cake loose from the sides of the
dust collection bag, increasing the amount of time that can be routed before the
dust collection bag will need to be serviced. (see page 58)
17. At the end of the day remove the cutter head dust shroud and store on the Shroud
Storage Bracket located on top of the cyclone.
Do Not leave the router resting
on the seal brushes as they will deform. Excessive deformation of the seal brushes will
hinder the shrouds ability to trap dust behind the shroud, reducing the efficiency of the
dust collector.
NOTE: DUST CONTROL ROUTER OPERATING PROCEDURES COMPLETED
18. As cutters wear , depth of cut will change. To compensate for cutter wear, repeat
step #2 as often as necessary to reset depth.
19. When cutters will no longer cut to desired depth, they must be replaced. Refer to
cutter changing section on Page 26.
20. Governor speed is set for the most efficient cutting action. Increasing engine
speed may hinder cutter action and also void warranty.