Crafco MODEL 30 PAVEMENT ROUTER, Инструкция по эксплуатации и запасным частям

Страница: 11 / 63

11
INTRODUCTION
MODEL 30 PAVEMENT ROUTER
The CRAFCO Model 30 Pavement Router was designed specifically to widen and clean
joints and cracks in asphalt and concrete surfaces. The CRAFCO Model 30 Pavement
Router is not intended to be used to clean old sealant from joints and cracks.
The CRAFCO Model 30 Pavement Dust Control Router is a self-contained unit; no exter-
nal power source is needed to operate the dust collection system. It was designed to reduce
the amount of fugitive dust particles being introduced into the air when widening and cleaning
joints and cracks in asphalt surfaces. The
CRAFCO Model 30 Pavement Dust Control
Router was not intended to pick up all dirt and debris from the joint or crack after routing.
The CRAFCO Model 30 Pavement Self-Propelled Router is a self-contained unit; no
external power source is needed to operate the drive system. It was designed to reduce
worker fatigue from moving from one distressed area to another. The
CRAFCO Model 30
Pavement Self-Propelled Router was not intended to drive forward and route cracks at the
same time. The handle bar has two seperate drive handles, standing at the operators position
the drive handle on the left works the electric clutch and the drive handle on the right works the
drive wheels.
CRAFCO, Inc. and its Distributors assume no liability for accident or injury incurred through
improper use of this machine.
DO NOT operate machine without reading operator’s manual and being thoroughly familiar
with controls:
1. Check engine crankcase oil. Add oil if low. Refer to Engine Operators Manual.
2. Fill engine gas tank with clean, fresh, unleaded gasoline. See “Fuel
Recommendations” in Engine Operators Manual.
3. Check tire inflation. Proper tire inflation is 45 psi. Machine will be difficult to roll with
under-inflated tires.
4. Check engine cooling air intake and external surfaces of engine. Clean if dirty or
obstructed.
5. Check that the air cleaner components and all shrouds, equipment covers, and guards
are in place and securely fastened.