CPS FA1000 SERIES, Руководство по эксплуатации

Страница: 18 / 24

Once the filter has been evacuated, the LCD will read:
Replace the filter with new ARXF5. Make sure the ARROW on the
filter points away from the Tank Liquid supply.
Then Push the NEXT key:
FILTER CHANGE (continued):
LCD will now read:
Use the +,-, KEYS to fill in the filter code for each blank.
Use the <,> KEYS to move cursor to the next blank
See filter label for code.
FILTER CHANGE
REPLACE FILTER
ORDER P/N
ARXF5
PUSH [NEXT]
NEXT >
ENTER FILTER ID
USE + - < >
KEYS
_ _ _ _ _ _ _ _
PUSH [ENTER]
UP +
DOWN -
RIGHT >
LEFT <
ENTER
FILTER REPLACEMENT
COMPLETE
RE-OPEN TANK LIQUID VALVE
PUSH [QUIT]
FILTER LIFE REMAINING:
100%
QUIT >
The LCD will now read:
Filter Change is now complete. Push the QUIT key to
return to MAIN MENU .
Push the ENTER key once the entire code is shown on LCD.
ENTER FILTER ID
USE + - < >
KEYS
_ _ _ _ _ _ _ _
PUSH [ENTER]
UP +
DOWN -
RIGHT >
LEFT <
ENTER
1 2 3 4 5 6 7 8
Automatic Non-condensable Gases (NCG) Purge: Upon start up of the unit, the NCG purge will begin automatically. If the compressor
was recently run, it could take up to 30 minutes before the NCG routine is allowed to run. To perform this operation, simply turn the unit
off and back on.
CHECK VACUUM PUMP OIL
10 hrs. OF RUN TIME HAVE
ELAPSED SINCE LAST OIL CHANGE
PLEASE CHANGE OIL
THEN PRESS [CONTINUE]
CONTINUE >
VACUUM OIL CHECK :
Every 10 hours of vacuum pump run time the following message will appear in EVACUATION or FULL CYCLE modes. The oil level can
be seen through the sight glass of the vacuum pump. To change the oil, first loosen the wing nut under the frame and then slide the
vacuum pump out. The vacuum pump oil should be clear, use CPS vacuum pump oil p/n VPOP, VPOQ, VPOG. Make sure the oil level
is up to the fill mark on the oil sight glass. Push CONTINUE key to proceed to the EVACUATION or FULL CYCLE modes.
18
AUTOMATICALLY OCCURING DURING THE OPERATION OF THE UNIT
MAINTENANCE