Electrical Connection
Doc. No.: 9.0020.0589B0
21 / 27
4.4.2 Create conduit entry holes
There is a removable plate at the bottom of the enclosure for customers to
create the conduit entry holes themselves. Perform as the following steps:
1.
Remove the bottom plate from the enclosure by loosening the
securing screws with a screwdriver.
2.
Remove the seal cushion from the bottom plate.
3.
Drill conduit entry holes on the bottom plate according to the
orientation, quantity and sizes of the cables.
Figure 4-4 Drill conduit entry holes
4.
Lay all relevant cables through corresponding entry holes to
proper connection points.
5.
After finishing the operation, recover the bottom plate and tighten
it again with its original screws.
IMPORTANT!
The dimensions of the entry holes depend on the sealing
protection method and cable size selected by the construction
party.
Waterproof connectors (Gland) are recommended.
