Mechanical Installation
Doc. No.: 9.0020.0589B0
17 / 27
Perform the following steps to open the Combiner:
1.
Turn the operation handle of the disconnect switch to the opened
position.
2.
Unlock the padlock and take it off from the lock hole (3).
3.
Lift the dovetail (4) of the hasp lock and separate the hasp (2) from
its staple (1);
4.
The door can be opened now.
3.4.2 Close the door
Perform the following steps to close the Combiner:
1.
Close the door;
2.
Lift the dovetail of the hasp lock, so that the hasp is hanged onto the
staple, and then press the dovetail down;
3.
Hang the padlock onto the lock hole of the hasp lock and lock it;
4.
Turn the operation handle of the disconnect switch to the closed
position.
IMPORTANT!
Before leaving the site after construction, make sure that the
Combiner is locked firmly, to prevent the door is damaged by heavy
rain or strong wind as well as the internal items get wet.
After closing the Combiner, It is possible to place a padlock on the operation
handle of the disconnect switch for Lockout/Tagout purposes, as shown below.
Figure 3-7 Padlock on the operation handle of disconnect switch
NOTICE!
Make sure the operation handle of the disconnect switch on the door
and the disconnect switch are both opened.
