CPI COTI, Техническое руководство

Страница: 109 / 170

Se
ctio
n
5
- En
gin
ee
r’s
Pro
gra
m
Technical Manual

Idle Time Seconds - This is the period of inactivity necessary prior to the reboot.
Enter the required period using the displayed numeric keypad and press Save.
5.11.23 Buzzer Settings
This enables the sounds when touching the selection interface buttons to be varied.
1. Buzzer Enabled - This Enables or Disables the buzzer.
2. Buzzer Selection - Select between Low Beep, Medium Beep or High Beep. This is the
length of the tone, reducing it makes it less intrusive in the local environment.
5.11.24 Debug Log Enable
This feature is Enabled or Disabled. When enabled this feature allows a log to be taken of
the events within the machine which can then be sent to technicalsupport@cranems.eu for
analysis.
The log is taken by inserting a USB stick (on which you have created a folder named “logs”
in the root menu) into the USB 3 socket on the atlas board. When the log has been
downloaded onto the stick the screen will instruct you to remove the USB stick.
Note: THIS FEATURE MUST BE ENABLED TO ALLOW AN MDB LOG TO BE TAKEN. (see
section 5.4.3)
5.11.25 Display OOS Errors
When enabled this feature will display errors on the User Interface seen by the customer.
5.11.26 LED Device Type
This enables the selection of the LED colour scheme.
1. Select the required colour type from those available on the LED Device Type screen to
display the colours available in that type.
2. Selecting Red LED will display a red colour scheme on the Display Screen.
3. Selecting RGB Led type allows various colour schemes to be activated. (if the necessary
hardware is fitted)
5.12 Security Codes
The security code for entry into the Engineer’s Program is factory set so that the engineer
presses the sequence of four numbers on the drink selection interface.
This screen enables these entry and keyless vend codes to be changed.
Note: On no account should the first three codes be altered without first consulting your
supervisor or manager.
1. Enter Pin - by entering the Operator PIN you will be taken into the Operator menu
2. Change Engineer PIN - this displays and enables the pin to be changed for entry into
the Engineer’s program.
3. Change Operator PIN - this displays and enables the pin to be changed for entry into
the Operator’s program.
99